Five Killer Quora Answers On Fiat 500 Replacement Key Cost
From Shiapedia
Fiat 500 Replacement Key Fob
It may be time to change the battery if your 500 remote key fob isn't working. However, if you replace the battery but it doesn't work it may be elsewhere.
United Locksmith specializes in the creation of new keys for classic cars. We have the tools and components needed for this job.
Dead Coin Battery
The most frequent reason why your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The coin cell battery in the key fob is likely to drain quickly if you don't use it often enough. If your remote began to show signs of weakening such as a loss in range and then completely stopped working, the battery is probably dead.
The battery in the key fob is secured by metal clips for retaining. If the clips aren't tight enough, it can cause problems with contact, which can prevent your remote from receiving power. Utilizing a small screwdriver, pry the retaining clip open to remove the current battery and replace it with a new one. Choose a battery that is the same voltage, size, and specification as the original.
Exposure to water can cause the key fob to become corroded or damaged. Even a quick bath in soapy water could damage the electronic chip inside. It is best to keep your key fob in a dry area.
Water Damage
If your key fob isn't working properly, it could be caused by water damage. Key fobs have rubber seals that prevent them from being damaged by rain or a splash of water, but it is very important to keep your car keys out of the pool, ocean, and washing machine!
The key fob has an electronic chip that transmits an electronic message to the immobilizer system of your vehicle. The chip is what allows the 500 to lock and start. If it gets wet it will cease to function.
Try cleaning the inside of your key fob's electronics using isopropyl alcohol, or an electronic cleaner to determine whether they're still in good condition. It is best to replace a key fob if it's submerged in salt water rather than attempting to fix it yourself.
While a replacement fob might cost you a bit of money, it is a lot cheaper than having to pay for your fiat 500 replacement key 500 to be towed to the dealer and repaired! You can also fix it yourself with only a few steps. Just ensure you have the correct battery type before you attempt to open your key fob. You can find step-by-step instructions for any key fob in your car online.
Faulty Chip
The chip inside the key fob connects directly with the immobiliser of your car to ensure that the vehicle will start only when the correct keys are used. If the chip is damaged or destroyed the car won't start regardless of what you do.
Water damage or a dead cell battery are the most frequently cited reasons for the chip being damaged. It is best to delegate the work to a professional locksmith, who can repair the chip in a short time and at a reasonable cost.
If your key fob stops functioning after exposure to clean water from the tap or rain, unplug the battery and clean the electronic component using a paper towel to ensure it's completely dry before putting it back in. If the key fob still fails to work it's most likely to be a damaged chip that must be replaced.
A few people turn to their dealer when in need of an entirely new Fiat key fob, however it can be a expensive option. If you're looking for a low-cost solution to have your Fiat key fob fixed then look no further than United Locksmith. We have the equipment and know-how to open fiat 500 boot without key necessary to fix your Fiat key fob in a quick and professional manner.
Faulty Receiver Module
Fiat key fobs send an electrical signal to the vehicle which will unlock and close doors (and start the car if it has an automatic transmission) up to 50 feet. There are a few reasons why the fob might stop working. This can be caused by a dead coin-battery water damage, worn out buttons, a receiver issue, signal interference or malfunctioning chips.
If the fob was placed in a pocket which has suffered extreme trauma (such as being dropped on the floor, or washed in the washer) it might not be able to communicate with the Body Control Module (BCM) of the vehicle. The BCM is a security system that only accepts signals from genuine keys.
You'll need to replace the fob in case this happens. A professional locksmith can handle all aspects of the key replacement process as well as programming a new one for the 500. In fact, they could offer you a clone key that works just the same as the original fob (and costs only a fraction of the price).
